Rohde & Schwarz SGT100A, Начало работы

Страница: 36 / 67

Instrument tour
R&S
®
SGT100A
36 Getting Started 1419.4576.02 ─ 10
1 2 3 4 6 7 8
11 10 9
5
Figure 5-2: R&S SGT rear panel controls and connectors
1 = AC power supply connector and power switch
2 = I/Q, I/Q Bar
3 = LAN
4 = PCIe
5 = USB IN
6 = DIG I/Q
7, 10 = USER 1/2
8 = RF 50Ω
9 = LO IN, LO OUT, REF IN, REF OUT
11 = I/Q
AC power supply connector and power switch
Mains power switch for performing the following tasks:
●
Connecting the internal power supply to the power source
●
Disconnecting the internal power supply from the power source
How to: Chapter 4.6, "Connecting to power" , on page 18
I/Q, I/Q Bar
SMB male connectors for output of direct (single-ended) or analog I/Q signals.
How to:
Chapter 4.8, "Connecting to RF 50
Ω
" , on page 19
LAN
RJ-45 connector to connect the R&S SGT to a LAN for remote control.
How to:
●
Chapter 4.7, "Connecting to LAN" , on page 19
●
Chapter 4.13.2, "Connecting a remote PC via LAN" , on page 27
PCIe
PCIe (Peripheral Component Interconnect Express) single lane interface for
remote control with optimized speed.
How to: "Connecting the Controller and the Instrument" in the R&S
SGT user
manual.
Rear panel tour