Rohde & Schwarz RTM20 Series, Руководство пользователя, Страница: 165 / 499

Protocol Analysis
R&S
®
RTM20xx
150 User Manual 1317.4726.02 ─ 01
Bus Type
Defines the bus or protocol type for analysis. For most types, a special option to the
instrument is required.
Remote command:
​
BUS<b>:
​
TYPE
​
on page 375
Configuration
Opens the configuration menu for the selected bus type.
Decode
Decodes the signal according to the protocol configuration and displays the decoded
signal - the content of every message. The decoding format is set with "Display".
Remote command:
​
BUS<b>:
​
STATe
​
on page 374
Display
Opens the "Display" menu, where you can:
●
Display the bit lines
●
Set the decoding format
●
Define labels for the bus and its lines
See:
​
chapter 11.1.3, "Display Settings" , on page 150
Frame Table
Opens the "Frame table" menu to configure and display the frame table with detailed
decoded data for each frame of the acquisition.
See:
​
chapter 11.1.5, "Frame Table: Decode Results" , on page 154
11.1.3 Display Settings
Access: PROTOCOL LOGIC > if "Logic" menu is displayed: "Protocol" > "Display"
Bits
Displays the individual bit lines above the decoded bus line.
Remote command:
​
BUS<b>:
​
DSIGnals
​
on page 375
Data format
Sets the decoding format of the data: Binary, Hexadecimal, Decimal or ASCII.
Remote command:
​
BUS<b>:
​
FORMat
​
on page 375
Basics of Protocol Analysis