Rohde & Schwarz R&S FPH, Руководство пользователя

Страница: 378 / 484

Remote Commands
R&S ® Spectrum Rider FPH
373 User Manual 1321.1011.02 ─ 06.00
Performing the Measurement
List of Commands
●
*WAI
on page 288
●
ABORt
on page 300
●
DISPlay<1...2>:BARGraph:PHOLd:RESet
on page 373
●
INITiate[:IMMediate]
on page 301
●
INITiate:CONTinuous
on page 301
●
[SENSe:]SWEep:COUNt
on page 301
●
[SENSe:]SWEep:TIME
on page 302
For a detailed description of commands refer to Chapter 13.6.2.4, "Performing and
Triggering Measurements" , on page 300 in spectrum analyzer mode.
DISPlay<1...2>:BARGraph:PHOLd:RESet
This command resets the maximum hold power level of the receiver frequency.
This command is an event and therefore has no query and no *RST value.
The numeric suffix at DISPlay is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Example:
DISP:BRAG:PHOL:RES
Usage: Event
Triggering Measurements
The following commands set up trigger conditions if you are using a trigger for the
measurement.
List of Commands
●
TRIGger[:SEQuence]:SLOPe
on page 304
●
TRIGger[:SEQuence]:SOURce
on page 304
For a detailed description of commands refer to Chapter 13.6.2.4, "Performing and
Triggering Measurements" , on page 300 in spectrum analyzer mode.
13.6.5.5 Working with Traces
The following commands set up the trace and the various functions associated with it,
e.g. trace mathematics or the selection of the detector.
List of Commands
●
CALCulate<1...2>:MATH<1...2>:COPY:MEMory
on page 305
●
DISPlay<1...2>[:WINDow]:TRACe<1...2>[:STATe]
on page 306
Remote Control - Commands