Rohde & Schwarz NRPM OTA Power Measurement Solution, Руководство пользователя

Страница: 78 / 229

Performing measurements
R&S
®
NRPM
78 Mannual 1425.8663.02 ─ 08
Access:
► In the settings navigation pane of the web browser-based user interface,
select "Trigger".
The remote commands required to define the trigger settings are described in:
●
Chapter 10.10, "Configuring the trigger" , on page 172
● Chapter 10.5, "Controlling the measurement" , on page 137
Trigger Source ...................................................................................................... 78
└ <Source> ................................................................................................... 78
└ <Slope> ..................................................................................................... 78
Trigger Level .........................................................................................................79
Trigger Delay ........................................................................................................ 79
Dropout ................................................................................................................. 79
Holdoff .................................................................................................................. 79
Hysteresis ............................................................................................................. 79
Trigger Source
Selects the source and slope polarity of the trigger signal.
You can use an internal or externally applied trigger signal.
<Source> ← Trigger Source
Selects the trigger source, see "Trigger sources" on page 139.
Remote command:
TRIGger:SOURce
on page 178
<Slope> ← Trigger Source
Sets the polarity of the active slope of the trigger signal.
"Positive" Uses the rising edge of the trigger signal.
"Negative" Uses the falling edge of the trigger signal.
Remote command:
TRIGger:SLOPe
on page 178
Measurement applications