Rohde & Schwarz NRP18A, Руководство пользователя

Страница: 153 / 165

Remote Control Basics
R&S
®
NRPxxA(N)
153 User Manual 1177.6017.02 ─ 05
Table 11-10: Meaning of bits used in the operation status register
Bit No. Meaning
0 Calibrating status register summary bit
This bit is set if the sensor is being calibrated.
See Chapter 11.3.8.1, "Operation Calibrating Status Register" , on page 153.
1 to 3 Not used
4 Measuring status register summary bit
This bit is set if the sensor is performing a measurement.
See Chapter 11.3.8.2, "Operation Measuring Status Register" , on page 154.
5 Trigger status register summary bit
This bit is set if the sensor is in the waiting for trigger state, i.e. waiting for a trigger event.
See Chapter 11.3.8.3, "Operation Trigger Status Register" , on page 154.
6 Not used
7 to 9 Not used
10 Sense status register summary bit
This bit is set if a sensor is initialized.
See Chapter 11.3.8.4, "Operation Sense Status Register" , on page 155.
11 Lower limit fail status register
This bit is set if a displayed value has dropped below a lower limit value.
See Chapter 11.3.8.5, "Operation Lower Limit Fail Status Register" , on page 155.
12 Upper limit fail status register
This bit is set if a displayed value has exceeded an upper limit value.
See Chapter 11.3.8.6, "Operation Upper Limit Fail Status Register" , on page 156.
13 to 14 Not used
15 Bit 15 is never used.
11.3.8.1 Operation Calibrating Status Register
The
CONDition
register contains information about whether a sensor is calibrated
and, depending on the configuration of the transition register. The
EVENt
register indi-
cates whether a calibration was started or completed since the last readout of this reg-
ister.
Querying the register:
●
STATus:OPERation:CALibrating:CONDition?
●
STATus:OPERation:CALibrating[:SUMMary][:EVENt]?
Status Reporting System