Rohde & Schwarz NRP T Series, Руководство пользователя

Страница: 50 / 169

Browser-Based User Interface
R&S
®
NRPxxT(N)
50 User Manual 1177.6023.02 ─ 08
"Repeating" Specifies that a measurement result is not output until the entire mea-
surement has been completed. This means that the number of mea-
surement cycle repetitions is equal to the set averaging factor. If the
averaging factor is large, the measurement time can be very long.
Remote command:
[SENSe<Sensor>:]AVERage:TCONtrol
Auto Measurement Time
Available only if "Noise Content" is set under "<Mode>" on page 46.
Sets an upper limit for the settling time of the auto-averaging filter, thus limiting the
length of the filter.
Remote command:
[SENSe<Sensor>:]AVERage:COUNt:AUTO:MTIMe
6.5.3 Trigger Settings
Describes the trigger parameters. You can define the conditions that have to be fulfilled
for a measurement to be triggered.
Further information:
●
Chapter 9.5.5, "Configuring the Trigger" , on page 76
●
Chapter 9.5, "Controlling the Measurement" , on page 69
Access: main dialog of the web user interface > navigation pane > "Trigger"
Trigger Source ...............................................................................................................50
└ <Source> ........................................................................................................ 50
└ <Slope> ...........................................................................................................51
Trigger Level ................................................................................................................. 51
Trigger Delay .................................................................................................................51
Dropout ......................................................................................................................... 51
Holdoff ...........................................................................................................................51
Hysteresis ..................................................................................................................... 51
Trigger Source
Groups the trigger source settings.
<Source> ← Trigger Source
Selects the trigger source. See Chapter 9.5.2.3, "Trigger Sources" , on page 71.
Remote command:
TRIGger:SOURce
Settings