Rohde & Schwarz EVSG-B1, Руководство пользователя

Страница: 75 / 418

Numeric Measurement Modes
R&S
®
EVSG1000
75 User Manual 1178.6227.02 ─ 06
Status flags
The "STIOCPMV" value contains status flags, if applicable:
●
S : Start (started manually)
●
T : Triggered (externally)
●
I : Invalid
●
O : Overload (RF input signal too high)
●
C : Corrected (includes RF input correction factor)
●
P : PPS-synced
●
M : Morse ID available
●
V : Valid signal (ILS LOC/GP and VOR only)
For details on data logging see Chapter 8.2, "Recording Measurement Data" ,
on page 217.
Remote commands to retrieve data:
GETDATADEF
on page 378
GETDATASET
on page 378
4.1.4 ILS Localizer and Glidepath Configuration
The following settings are available for the ILS Localizer and Glidepath measurements.
Settings for recording, including trigger settings, are described in Chapter 8.2, "Record-
ing Measurement Data" , on page 217.
● Configuring the Input Signal ....................................................................................75
● Channel and Frequency Configuration ................................................................... 76
● Ampt ........................................................................................................................80
● Bandwidth (BW) ...................................................................................................... 81
● LF Input Configuration .............................................................................................82
● Setting the Measurement Time (MTime) .................................................................86
● DDM and SDM Configuration ..................................................................................86
4.1.4.1 Configuring the Input Signal
The ILS modes can analyze RF or LF input. For details on configuring LF input mea-
surements, see
Chapter 4.1.4.5, "LF Input Configuration" , on page 82.
Input RF/LF
Access
: [Config]
Access VNC : [s]
ILS Localizer and ILS Glidepath (GP) Modes