Rohde & Schwarz EVSG-B1, Руководство пользователя

Страница: 227 / 418

Common Instrument Settings
R&S
®
EVSG1000
227 User Manual 1178.6227.02 ─ 06
Demod
Selects between AM / FM modulation for receiver signals.
Audio BW
Frequency range to be output to the speaker or headphones.
"Full" Full bandwidth is output
"Voice (def)" Voice frequencies (> 3 kHz) filtered out
"ID Notch" ID frequency (1020 Hz) filtered out
"V/ID Notch" Voice and ID frequencies filtered out
Remote command:
SETUP:AUDIOBW
on page 255
Speaker
Enables or disables AF output at the loudspeaker on the rear panel of the
R&S
EVSG1000.
Remote command:
SETUP:SPEAKER
on page 257
KB Beep
Enables or disables a tone when a key on the keyboard is pressed. This is useful as
feedback during operation in a noisy environment.
9.2 Display
Access : [Display]
Access VNC : [v]
(Not in "Preset" view.)
Some general settings are available for the display on the R&S EVSG1000. In particu-
lar, you can configure the display brightness depending on the used power source.
RX Unit 1 / RX Unit 2 .................................................................................................. 227
Level View ...................................................................................................................228
Zoom ........................................................................................................................... 228
Brightness Mains .........................................................................................................228
Brightness Battery .......................................................................................................229
RX Unit 1 / RX Unit 2
Select the receiver board whose settings and results are displayed. The currently
selected receiver board is indicated by a vertical blue line on the softkey.
This setting is only available if a second receiver board is installed (requires the
R&S
EVSG-B1 option, see Chapter 3.2, "Receiver Board" , on page 52).
While two different measurements can be performed simultaneously using two receiver
boards, the results can only be displayed for one board at a time. Use this function to
toggle between the two measurements.
Display