Remote Control
R&S
®
ESRP
921
User Manual 1175.7445.02 ─ 08
Manual operation:
See
"Defining characteristics of a transducer factor"
[SENSe:]CORRection:TRANsducer:SELect
<FileName>
This command creates or selects a transducer factor.
Parameters:
<FileName>
String containing the name of the transducer factor.
If the name does not exist yet, the R&S
ESRP creates a trans-
ducer factor by that name.
Example:
See
"Designing a transducer factor"
Manual operation:
See
"Using transducer factors or transducer sets"
See
"Defining characteristics of a transducer factor"
[SENSe:]CORRection:TRANsducer[:STATe]
<State>
This command turns a transducer factor on and off.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect
.
You can turn on up to 8 transducer factors at the same time.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
See
"Designing a transducer factor"
Manual operation:
See
"Using transducer factors or transducer sets"
[SENSe:]CORRection:TRANsducer:UNIT
<Unit>
This command selects the unit of a transducer factor.
Before you can use the command, you have to select a transducer factor with
[SENSe:]CORRection:TRANsducer:SELect
.
Parameters:
<Unit>
String containing one of the following units:
DB | DBM | DBMV | DBUV | DBUV/M | DBUA DBUA/M | DBPW |
DBPT
*RST:
DB
Example:
See
"Designing a transducer factor"
Manual operation:
See
"Defining characteristics of a transducer factor"
Using Transducers