Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 908 / 1094

Remote Control
R&S
®
ESRP
905 User Manual 1175.7445.02 ─ 08
Before you can use the command, you have to feed in a calibration signal with
DIAGnostic<n>:SERVice:INPut[:SELect]
on page 905.
Suffix:
<n>
.
irrelevant
Parameters:
<Frequency> Possible frequencies of the calibration signal are fix.
If you define a frequency that is not available, the R&S
ESRP
uses the next available frequency. Example: a frequency of
20
MHz is rounded up to the next available frequency
(21.33 MHz).
*RST: 64 MHz
Example: DIAG:SERV:INP:PULS:CFR 128 MHz
Defines a calibration signal frequency of 128 MHz.
Usage: SCPI confirmed
Manual operation: See "Calibration Frequency RF" on page 498
DIAGnostic<n>:SERVice:INPut[:SELect] <Signal>
This command selects the source of the signal.
You can feed in a signal from the RF input or the calibration signal.
Suffix:
<n>
.
irrelevant
Parameters:
<Signal> RF
RF input
CALibration
Calibration
*RST:
RF
Example: DIAG:SERV:INP CAL
Selects the calibration signal as the input signal
Manual operation: See "RF" on page 498
DIAGnostic<n>:SERVice:STESt:RESult?
This command queries the self test results.
Suffix:
<n>
.
irrelevant
Parameters:
<Results> String of data containing the results.
The rows of the self test result table are separated by commas.
System Configuration