Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 664 / 1094

Remote Control
R&S
®
ESRP
661 User Manual 1175.7445.02 ─ 08
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example: CALC:MARK2:MAX:NEXT
Positions marker 2 to the next lower maximum value.
Usage: Event
Manual operation: See "Next Peak" on page 181
See "Next Mode" on page 181
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]
This command positions the marker on the current trace maximum.
The corresponding marker is activated first or switched to the marker mode.
If no maximum value is found on the trace (level spacing to adjacent values < peak
excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
<m> depends on mode
Selects the marker.
Example: CALC:MARK2:MAX
Positions marker 2 to the maximum value of the trace.
Usage: Event
Manual operation: See "Peak" on page 181
CALCulate<n>:MARKer<m>:MAXimum:RIGHt
This command positions a marker to the next smaller trace maximum on the right of
the current value (i.e. in ascending X values).
If no next smaller maximum value is found on the trace (level spacing to adjacent val-
ues < peak excursion), an execution error (error code: -200) is produced.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example: CALC:MARK2:MAX:RIGH
Positions marker 2 to the next lower maximum value to the right
of the current value.
Usage: Event
Manual operation: See "Next Mode" on page 181
Remote Commands in Receiver Mode