System Configuration
R&S
®
ESRP
496
User Manual 1175.7445.02 ─ 08
Remote command:
Clear All Messages ← System Info
Deletes all system messages. The softkey is only available if the "System Messages"
dialog box is displayed.
Remote command:
Parameter Coupling
Opens a dialog box to couple or decouple various parameters.
If the coupling of a parameter is on, its value is transferred when you switch from
receiver into another operating mode and vice versa. Coupling of the following parame-
ters is supported.
●
Frequency
●
Span (start and stop frequencies)
●
Marker frequency
●
RF attenuation and unit
●
10 dB Minimum Attenuation
●
Preamplifier state
●
Preselector state
Note that the preselector is always on in receiver mode.
●
Audio demodulation settings
●
Bandwidth settings (including filter type)
●
Limit lines
Limit lines are only transferred if they are compatible to the current diagram config-
uration.
Remote command:
See
Chapter 11.9.3, "Coupling Parameters"
Firmware Update
Opens the "Firmware Update" dialog box.
Enter the name of or browse for the firmware installation file and press the "Execute"
button. For details on installation, refer to
Chapter 3.3, "Firmware Update and Installa-
Only user accounts with administrator rights can perform a firmware update.
Remote command:
Option Licenses
Opens a submenu to install options. For details on options, refer to
ware Update and Installation of Firmware Options"
The submenu contains the following commands:
●
●
Only user accounts with administrator rights are able to install options.
Instrument Setup and Interface Configuration – SETUP Key