Receiver Mode
R&S
®
ESRP
188
User Manual 1175.7445.02 ─ 08
Remote command:
Delete
Deletes the selected limit line.
Remote command:
X Offset
Horizontally shifts a limit line that has been specified for relative frequencies or times
(x-axis). The softkey opens an edit dialog box in which the value for shifting can be
entered numerically or via the rotary knob.
Note:
This softkey does not have any effect on limit lines that represent absolute val-
ues for the x-axis.
Remote command:
CALCulate<n>:LIMit<k>:CONTrol:OFFSet
Y Offset
Vertically shifts a limit line that has relative values for the y-axis (levels or linear units
such as volt). The softkey opens an edit dialog box in which the value for shifting can
be entered numerically or via the rotary knob.
Note:
This softkey does not have any effect on limit lines that represent absolute val-
ues for the y-axis.
Remote command:
CALCulate<n>:LIMit<k>:LOWer:OFFSet
CALCulate<n>:LIMit<k>:UPPer:OFFSet
Display Lines
Opens a submenu to enable, disable and set display lines. Which softkeys are availa-
ble depends on the display mode (frequency or time range).
Chapter 5.4.3.2, "Display Lines"
ter 5.4.3.4, "Working with Lines"
The submenu contains the following functions:
●
"Display Line 1 / Display Line 2"
●
"Display Line 1 / Display Line 2"
●
"Frequency Line 1 / Frequency Line 2 "
●
"Frequency Line 1 / Frequency Line 2 "
●
●
●
Display Line 1 / Display Line 2 ← Display Lines
Enables or disables the level lines 1/2 and opens an edit dialog box to enter the posi-
tion of the lines.
Chapter 5.4.3.2, "Display Lines"
ter 5.4.3.4, "Working with Lines"
Common Analysis Functions