Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 141 / 1094

Receiver Mode
R&S
®
ESRP
138 User Manual 1175.7445.02 ─ 08
Available for interactive final measurements.
Remote command:
-
Get Maxhold
Uses the highest level that was measured during the scan for the final results instead
of the signal level measured during the final measurement.
Remote command:
-
Measure
Initiates a final measurement on the current peak.
Available for interactive final measurements.
Remote command:
-
Stop Final Measurement
Aborts the final measurement.
Data that has already been collected is lost.
Remote command:
ABORt
on page 609
5.1.7.6 Measurement Settings
The "Meas" menu contains the basic measurement settings and the selection of result
displays (
Chapter 5.1.7.2, "Selecting the Result Display" , on page 132).
► Press the [MEAS] key.
The R&S ESRP opens the "Measurement" menu.
Receiver Frequency .................................................................................................... 138
Bargraph Detector .......................................................................................................139
└ Couple to Scan Trace ................................................................................... 139
Measurement Time ..................................................................................................... 139
Demod .........................................................................................................................139
└ Demod (On Off) ............................................................................................ 139
└ AM / FM ........................................................................................................ 139
└ Squelch .........................................................................................................139
Add To Peak List ......................................................................................................... 140
Test Automation .......................................................................................................... 140
Receiver Frequency
Defines the receiver frequency.
The tuning frequency has to be set to at least twice the IF bandwidth.
When the tuning frequency is lower than twice the IF bandwidth, the IF bandwidth is
automatically reduced so that this condition is met again.
Measurements and Result Displays