Rohde & Schwarz CLIPSTER 6 Mk2, Руководство пользователя

Страница: 50 / 78

Maintenance
Removing the Top Cover
CLIPSTER
50
User Manual (Hardware) | 2904.4460.02 - 04
4. Once the front cover of the system is back in place, the replacement of
the SSD disk is finished. After several minutes the replaced SSD disk will
be automatically recognized by the system. Then the rebuild of the data
will be initiated automatically. When the system has finished the rebuild,
the system will be fully operational again.
Removing the Top Cover
This section guides you through the process of opening the casing. This is
required e.g. in case you have to replace a defective PCI board or a cooling
fan.
Perform the following steps:
1. Shut down the system as described in section “Shutting Down the
System” on page 41. and remove all power cords.
2. Press the release button x 2 on both sides of the chassis.
The disk carrier of the replaced disk should be level with the others of the ar-
ray.
File Access to the Disk Array
During a rebuild, real-time processing may not be possible.
It is recommended to restrict file access to the SSD disk
array until the rebuild is finished, as it takes several hours.
Avoid file access operations to the disk array during
this time, otherwise it may take considerably longer.
High Voltage
The system you are working on operates with voltages that can be
hazardous to your health.
Do not work on the system or access its interior with the power
cables being plugged in.
Make sure the power supply is disconnected from the compo-
nents you intend to work on.
System Damage
The system must be operated only with the chassis’ cover installed to
ensure proper cooling.