Rohde & Schwarz AREG100A, Руководство пользователя, Страница: 189 / 321

Remote Control Commands
R&S
®
AREG100A
189 User Manual 1178.7417.02 ─ 04
*RCL <Number>
Recall
Loads the instrument settings from an intermediate memory identified by the specified
number. The instrument settings can be stored to this memory using the command
*SAV
with the associated number.
It also activates the instrument settings which are stored in a file and loaded using the
MMEMory:LOAD <number>, <file_name.extension>
command.
Manual operation: See "Recall Immediate x" on page 84
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
The command is equivalent to
SYSTem:PRESet
.
Usage: Setting only
Manual operation: See "Preset" on page 78
*SAV <Number>
Save
Stores the current instrument settings under the specified number in an intermediate
memory. The settings can be recalled using the command
*RCL
with the associated
number.
To transfer the stored instrument settings in a file, use the command
:MMEMory:
STORe:STATe
.
To transfer the stored instrument settings in a file, use the com-
mand
:MMEM:STOR:STAT
.
Manual operation: See "Save Immediate x" on page 83
*SRE <Contents>
Service request enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
Parameters:
<Contents> Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range:
0 to 255
Common Commands