Rohde & Schwarz 1430.0105K02, Руководство пользователя

Страница: 133 / 206

Remote Control
R&S
®
NRT2
133 User Manual 1178.5550.02 ─ 04
11.9 INPut
INPut<Sensor>:PORT:OFFSet
........................................................................................ 133
INPut<Sensor>:PORT:POSition
.......................................................................................133
INPut<Sensor>:PORT:SOURce[:VALue]
...........................................................................133
INPut<Sensor>:PORT:SOURce:AUTO
............................................................................. 134
INPut<Sensor>:PORT:OFFSet <offs>
This command allows the transmission loss in a cable connecting the desired mea-
surement point and the sensor to be taken into account. If the measurement position is
set to LOAD, i.e.
INPut<n>:PORT:POSition LOAD
, the cable is assumed to be con-
nected between the sensor and the load, otherwise between the sensor and the
source.
Parameters:
<offs> Range: 0.0 to 100.0
*RST: 0.0
Default unit: dB
Example: INP1:PORT:OFFS 1.25
Manual operation: See "Offset" on page 54
INPut<Sensor>:PORT:POSition <pos>
This command selects the reference plane. It defines the sensor port to which the
measurement results are to be referred to.
Parameters:
<pos> SOURce | LOAD
SOURce
Referred to source.
LOAD
Referred to load.
*RST:
SOURce
Example: INP2:PORT:POS SOUR
Manual operation: See "Offset Reference Plane" on page 54
INPut<Sensor>:PORT:SOURce[:VALue] <val>
Defines the forward direction for the given input if the automatic assignment has been
switched off by
INPut{Sensor{1...128}}:PORT:SOURce:AUTO OFF
.
Parameters:
<val> Range: 1 to 2
*RST: 1
Manual operation: See "Direction" on page 53
INPut