Rohde & Schwarz 1424.7805.02, Руководство пользователя

Страница: 126 / 522

Sensor Configuration
R&S
®
NRX
126 User Manual 1178.5566.02 ─ 08
Range State ................................................................................................................ 126
Range ..........................................................................................................................126
User Defined Transition ...............................................................................................126
Offset ...........................................................................................................................127
Attenuator Mode ..........................................................................................................127
Attenuation .................................................................................................................. 127
Range State
Enables or disables the automatic measurement path selection.
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>][:POWer][:AVG]:RANGe:
AUTO
on page 344
Range
Available if Range State is set to "User".
Sets the active measurement path in which the power sensor is measuring.
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>][:POWer][:AVG]:RANGe[:
VALue]
on page 345
User Defined Transition
Available if Range State is set to "Auto".
Enables or disables the reduction of the transition range between the measurement
paths, entered under
Offset .
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>][:POWer][:AVG]:RANGe:
CLEVel:STATe
on page 345
Range Settings
www.allice.de Allice Messtechnik GmbH