Putting into Operation
R&S
®
RT-ZC20B
14
User Manual 1409.8285.02 ─ 04
Figure 3-1: Connecting the probe to the Rohde
&
Schwarz oscilloscope
► To disconnect the probe:
a) Press and hold the release button (3).
b) Pull the probe box away from the oscilloscope.
3.2
Identification of the Probe
When the probe is connected to the oscilloscope, the oscilloscope recognizes the
probe and reads out the probe-specific parameters.
The oscilloscope settings for attenuation and offset are automatically adjusted;
and the oscilloscope switches to high impedance coupling (1
M
Ω
) to ensure accu-
rate measurements.
The complete probe information is shown in the probe settings dialog. For more
information, refer to the user manual of your oscilloscope.
Identification of the Probe
www.allice.de
Allice Messtechnik GmbH
