Rohde & Schwarz 1333.2401.02 Скачать руководство пользователя страница 4

Safety and regulatory information

R&S

®

RT-ZP05S

4

User Manual 1179.5124.02 ─ 02

Declaration of Conformity

The manufacturer declares the conformity of this product with the actual required
safety standards in accordance with the Low Voltage Directive IEC 61010-031
Safety requirements for electrical equipment for measurement, control and labo-
ratory use.

Part 031: Safety requirements for hand-held probe assemblies for electrical mea-
surement and test

Measurement Categories

IEC 61010-2-030 defines measurement categories that rate instruments on their
ability to resist short transient overvoltages that occur in addition to the working
voltage. Use the measurement instrument and accessories only in electrical envi-
ronments for which they are rated.

0 - Instruments without rated measurement category
For measurements performed on circuits not directly connected to mains, for
example, electronics, circuits powered by batteries, and specially protected
secondary circuits. This measurement category is also known as CAT I.

CAT II:
For measurements performed on circuits directly connected to the low-voltage
installation by a standard socket outlet, for example, household appliances
and portable tools.

CAT III:
For measurements performed in the building installation, such as junction
boxes, circuit breakers, distribution boards, and equipment with permanent
connection to the fixed installation.

CAT IV:
For measurements performed at the source of the low-voltage installation,
such as electricity meters and primary overcurrent protection devices.

Disposal

This electronic product is classified within the WEEE/ RoHS category list as
monitoring and control equipment (category 9). Category 9 products are
exempted from the restrictions under the scope of the RoHS directive.

Rohde

 

&

 

Schwarz has developed a disposal concept for the ecofriendly disposal

or recycling of waste material. Rohde

 

&

 

Schwarz fully assumes its obligation as a

producer to take back and dispose of electrical and electronic waste. Contact
your local service representative to dispose of the product.

Содержание 1333.2401.02










Отзывы: