GUI Reference
R&S
®
ZNA
359
User Manual 1178.6462.02 ─ 12
The "Define Limit Line..." button opens the "Define Limit Lines" dialog (see
ter 6.6.1.2, "Define Limit Lines Dialog"
Show Limit Line
Shows or hides the limit line associated with the active trace in a Cartesian diagram
area.
The limit line colors are defined in the
Define User Color Scheme Dialog
[Display] > "Config" > "Define User Color..."). You can choose between various options:
●
Display upper and lower limit lines with different colors.
●
Assign the same color to traces and associated limit lines.
●
Assign different colors to limit line segments with disabled limit check.
Note:
Display of the limit line and limit check are independent of each other: Hiding the
limit line does not switch off the limit check.
Remote command:
CALCulate<Chn>:LIMit:DISPlay[:STATe]
Limit Check
Enables/disables the limit check for the active trace.
If enabled, an additional info field is displayed in the diagram, indicating the "PASS" or
"FAIL" state. Limit violations are marked with a colored square. An acoustic signal
(
) and a TTL signal indicating pass or fail can be generated in addition.
Lines Softtool
