Rohde & Schwarz 1322.8003K06, Начало работы

Страница: 37 / 85

Instrument Tour
R&S
®
FSPN
37 Getting Started 1179.4370.02 ─ 01
For information about the trigger in- and output available on the rear panel, see
Chapter 4.1.12, "Trigger Input and Output" , on page 35.
The digital baseband in- and outputs shown in the image above are not supported
by the R&S
FSPN.
● Removable Hard Disk ..................................................................................... 37
● AC Power Supply Connection and Main Power Switch .................................. 37
● Display Port and DVI .......................................................................................38
● LAN ................................................................................................................. 38
● USB Ports ....................................................................................................... 38
● Sync Trigger Input and Output ........................................................................ 38
● Aux. Port ......................................................................................................... 39
● GPIB Interface .................................................................................................39
● OCXO ..............................................................................................................39
● REF INPUT / REF OUTPUT ........................................................................... 39
● Labels on R&S FSPN ......................................................................................40
● Device ID .........................................................................................................40
4.2.1 Removable Hard Disk
The removable hard disk is accessible from the rear of the instrument.
In addition to the operating system and the firmware, the R&S FSPN also stores
measurement data on that disk. When you remove the hard disk, you can store it
and the data on it somewhere secure.
4.2.2 AC Power Supply Connection and Main Power Switch
An AC power supply connector and main power switch are located in a unit on
the rear panel of the instrument.
Main power switch function:
Position 1: The instrument can be started via the Power key on the front panel.
The OCXO reference frequency is warmed up.
Position O: The entire instrument is disconnected from the AC power supply.
For details, refer to "Connecting to power" on page 5 and Chapter 3.5, "Connect-
ing the AC Power" , on page 14.
Rear Panel View