Remote Commands
R&S
®
Spectrum Rider FPH
474
User Manual 1321.1011.02 ─ 11
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
SYST:POS:GPS ON
Activates the GPS receiver.
SYSTem:POSition:LATitude?
This command queries the latitude of the current position of the R&S Spectrum Rider.
Example:
SYST:POS:LAT?
Return value would be, for example, 48,7,40.0 for 48°, 7 ', 40.0"
in the northern hemisphere.
Usage:
Query only
SYSTem:POSition:LONGitude?
This command queries the longitude of the current position of the R&S Spectrum
Rider.
Example:
SYST:POS:LONG?
Return value would be, for example, 11,36,46.2 for 11°, 36',
46.2" East.
Usage:
Query only
SYSTem:POSition:VALid?
This command queries if the current position is valid.
Example:
SYST:POS:VAL?
Usage:
Query only
13.6.11.3
Display Configuration
This chapter describes commands to set up the display of the R&S Spectrum Rider via
remote control.
List of commands
............................................................................................ 474
........................................................................................475
........................................................................................ 475
DISPlay<1...2>:BRIGhtness
<Brightness>
This command sets the brightness of the display backlight.
Remote Control - Commands
www.allice.de
Allice Messtechnik GmbH
