In addition to operating the digital box, the Rogers remote
is capable of controlling basic commands on your TV, VCR
and other components. To enable these features, the Rogers
remote must be programmed for your particular home
entertainment components.
There are two ways to program the Rogers remote to
control your equipment; searching for the correct code or
entering the code directly. If you have Internet access, your
component codes are available online. Follow the
instructions on the next page of this guide once you have
the codes.
The alternative is to search for the codes using the steps
below.
SEARCHING FOR YOUR CODE
To search for a code for your TV:
1.
Turn on your TV.
2.
On the remote control, press
TV
once; it will
blink once. Press and hold
SETUP
until the
TV
button blinks twice, then release
SETUP
.
3.
Enter
9
-
9
-
1
. The
TV
button will blink twice.
4.
Aim the remote control toward the TV and
press
PWR
once.
5.
Press
CH+
repeatedly until the TV turns off.
NOTE
: In search mode, the remote control will
send device codes from its library to the
selected device, starting with the most
popular code first.
You may have to press
CH+
dozens of
times until the correct code is found.
6.
After your TV has turned off, press
SETUP
once to lock in the code. The
TV
button will
blink twice.
Searching codes for other devices
Since the Rogers remote control is a universal remote, you
can program it for other components by repeating the steps
above and substituting the
TV
button with the respective
device button (
DVD
,
AUD
, etc.).
-6-
PROGRAMMING YOUR REMOTE
45709 URC Guide:Layout 1 07/12/09 10:12 AM Page 6
