Roger SL2000B, Руководство пользователя

Страница: 8 / 13

Electronic Code Locks SL2000B v1.4 and SL200S1K v1.3 EN Rev.C.doc 2011-11-16
Strona 8 z 13
INSTALLER Code
All digits are “2” (2222…), the length of the code depends on the C10 parameter entered
later during Memory Reset procedure.
USER Code no01
All digits are “3” (3333…), the length of the code depends on the C9 parameter entered
later during Memory Reset procedure.
All USER codes 02..55
All USER codes no 02 -55 are blank (they doesn’t exist).
Installation
 The SL2000 code lock should be mounted near the supervised door on a vertical
piece of supporting structure.
 The SL2000S1k can be installed either indoor or outdoor location, SL2000B can be
installed in indoor location only.
 Assure that the surface beneath of the controller’s rear panel is flat and smooth.
 Disconnect power supply before making any electrical connections.
 Once installed and electrically connected, the unit has to be properly programmed.
 When forgotten, MASTER and INSTALLER codes can be restored to their default
values and then programmed again.
 Use separate pair of wires to supply door lock and SL2000 code lock.
 It is forbidden to supply the door lock directly from the DC input terminals of the
code lock.
 Always add the silicon diode (e.g. 1N4007) in parallel to the door lock, note that
diode must be located as close as possible to the door lock terminals.
 Do not attempt to use REL1 output for switching of voltages higher then 24V
DC/AC.