RWH-1 Operating manual.doc
2018-11-30
Page
4
of
11
·
When RUD-1 is inserted into computer USB port, short RST pins and orange LED SYSTEM
indicator on the hub shall pulsate frequently.
·
Start RogerVDM software.
·
Select type of device (RWH-1), RS232 communication channel and serial port with
connected RUD-1 interface.
·
Select required settings.
·
Make backup by saving settings to file (button:
Send to File…
).
·
Upload settings to the lock (button:
Send to device
).
·
In RogerVDM select Device/Disconnect.
·
Short RST pins for a moment to restart device.
Fig. 2. Connection of RWH-1 to RUD-1 interface
Configuration parameters
The table below includes RWH-1 configuration parameters which can be modified using RogerVDM
software within low level configuration of device.
Parameter
Function
RS485 address
The parameter defines device address on RS485 bus. Range: 100-
115.
RS485 encryption
When the option is enabled then the communication between
device and access controller is encrypted.
RS485 encryption key
The parameter defines key used for encryption of communication
between device and access controller.
RS485 communication
timeout
The parameter defines delay after which device will signal lost
communication with controller. Range: 0-64s.
Radio channels
Parameter defines radio channels which are enabled for device.
When radio network is created the hub automatically selects
