Rodgers Allegiant 657, Руководство пользователя

Страница: 61 / 76

51
MIDI Save
Many changes to MIDI settings are temporary and are lost when the organ is turned off.
However, the MIDI Save procedure can store many of these new settings as the default, so that
the change is retained when the organ is powered off.
Please note that there are a few MIDI settings that cannot be changed and saved using the MIDI
Save procedure.
Saving MIDI Control Settings
To perform the MIDI Save procedure:
1. While in any MIDI menu, make the desired changes.
2. Press and hold the SET piston, then press and hold General Cancel (‘0’).
Continue to hold both pistons for approximately five seconds, until the
following screen is displayed:
M I D I C o n t r o l
S e t t i n g s S a v e d
Release both pistons. The changes have been saved as the default.
Saving a Combination Memory to a Sequencer
The contents of any combination memory may be saved to a MIDI sequencer and later reloaded
into the organ. This allows storage of registrations in an external device.
Saving a Combination Memory
To save a combination memory to a sequencer:
1. Make sure the sequencer is connected correctly to the MIDI IN and MIDI OUT
jacks.
2. Start the sequencer in Record mode.
3. Wait until sequencer is recording (after the count-in measures, if any) then hold
SET and momentarily press the memory piston (657:
M1 or M2 , 677: M1, M2,
M3 or M4 ) corresponding to the memory you wish to store.
4. Release both pistons. The console display will read: