Technical Data
Surface Preparation
All surfaces should be clean, dry and dust free before
application. Any surfaces covered in heavy grime/grease
should be cleaned with a suitable water washable,
multipurpose degreaser. Ensure that the surface is thoroughly
rinsed and allowed to dry before application.
Steel Surfaces
Clean the surface thoroughly before application. If possible,
abrade the surface to improve adhesion.
Concrete
The surface should be cleaned thoroughly before use. All
surface latence should be removed. On new or polished
concrete, treatment with an acid etch solution is recommended
prior to application of EASYLINE
®
EDGE. Alternatively,
mechanically etch the surface by scabbling.
Asphalt
Asphalt should be free from dust, dirt, and grease etc. If
necessary, the surface should be cleaned by pressure washing
and allowing the asphalt to dry thoroughly before application of
EASYLINE
®
EDGE.
To avoid asphalt bleed on very new tarmac/asphalt surfaces,
apply a quick line as a primer and leave to dry for 20 minutes
before overcoating.
Timber
Sand the surface to remove any weak timber or contamination.
Not suitable for hardwoods with high tannin content or
traditional railway sleepers which may result in tannin bleed
and pour adhesion.
Painted Surfaces
Caution, perform a small test area before coating. Lightly
abrade the surface before application. Check for compatibility.
May damage the existing surface. Removal will not be possible
without damage to the existing finish.
Assembly Instructions
01. Remove the components from the case.
Note: All adjustable or detachable components are colour coded
yellow (except red silicone brushes)
02.
Note: New Applicators are supplied with the masking plates
already fitted.
To re-assemble and attach the masking plates after use:
A&B:
First attach the silicone brushes to the pegs on the
back of the masking plates. Ensure that the back of each
red silicone brush is flush with the back of the masking
plate.
03.
C&D:
If desired, fit the pointer to the front of a masking
plate. Right-handed people should fit the pointer to the
left masking plate as shown.
04.
E:
Attach the assembled masking plates into the wheeled
base unit as shown. They should click into place.
F:
The complete base unit assembly should look like this.
05.
G:
Insert the AA battery. Slide the yellow battery cover
upwards, insert the battery positive end up, push the
battery down and in.
06.
H:
Switch on the fans and
I:
check that air is blowing
down, behind the masking plates. (Switch off the fans
when not in use).
07.
J:
Attach the handle to the base unit and push down until
K:
the yellow buttons click into the 100mm height setting
08. Extend the handle.
L:
Depress the small yellow buttons at the base of the
handle.
M&N:
Pull the handle up until
O:
the yellow buttons re-
engage into the fully extended position.
09. Adjust the angle of the handle.
P:
Press and hold the yellow button on the hinge and
Q:
pull back the handle to the desired angled before
releasing the button.
10. Set the desired line width.
R:
First adjust the width by turning the wheel until the
desired width is at the edge of the visible gauge. Note the
colour zone in which the width setting resides.
S:
Then adjust the height of the can holder to the matching
colour zone. Pinch the yellow buttons on either side and
whilst holding the base unit down with the other hand,
slide the can holder to the required position.
Assembley Instructions (with reference on next page)
Click here for assembly instruction video
