GB
GB
Starting locomotive operation
Maintenance of the model
Unwrap model:
Take out the model cautiously
with foil (fig. 1).
Very important!
Before taking into service
your model the-
se bearings of the
coupling rods must be
oil ed
as otherwise there would be the risk of
bad running qualities of damage on the loco-
motive (see fig. 4).
Operating instructions:
Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is H0e
Standard R = 261,8 mm.
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no.
10002, ROCO track cleaning rubber
, for
remo-ving heavy dirt.
Fittings:
Operation is possible with different cou-
plings (fig. 2).
In the enclosed accessory bag you will find small
kits to be fitted on your locomotive. Please
mount
them cautiously.
Attention!
Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface.
Finally put the plug of the chip into the interface
as shown in fig. 5.
To enjoy your model for a long time, it is neces-
ary to
service
it regulary (i.e. after it has been in
ope-ration for approximately 30 hours).
1. Cleaning of wheel contacts:
Wheel cont-
acts easily get dirty on tracks which are not enti-
rely clean. Use a small brush to
remove dirt
from
spots marked in fig. 6.
2. Lubrication:
Apply
tiny oil drops
to spots
marked in fig. 4+8. Prior to lubrication dismantle
locomotive (fig. 3). We recommend using item no.
10906, ROCO oiler
. For lubrication the gearparts
(e.g. cogwheels, worm) we whould recommended
our ROCO
special grease
(item no.
10905
).
Attention:
Please do not oil these parts when
using our grease.
3. Change of lights:
First remove loco body
(fig. 3) and then change lights (fig. 7).
4. Carbon Brush Changing:
First remove loco
body (fig. 3), and then change the
carbon brus-
hes
or the
motor
(fig. 9).
Assembly:
During assembly please take care of
correct position of contacts.
10
3
