Installation Instructions
Prepare Mounting Surface
Mark locations and drill holes on mounting surface.
(Holes fit M6 or 1
/4"
bolts and are spaced 96m)
0
----
96mm----
Install Axle Adaptor
Loosen set screws and slide adaptor out. Install
appropriate adaptor and tighten set screws.
(1Sxl00 axle adaptor pre-installed)
Warnings
Install HotRod
Mount HotRod onto surface using appropriate
fasteners and washers. For track applications
loosely install track hardware and slide onto track.
Position and tighten
Install Bike
Remove front wheel. Load fork onto HotRod and
install thru axle. Refer to fork's owner's manual for
instructions. Shake bike to ensure bike is secure
Remove Baby Seats, Panniers, U-Locks, or items that could detach from the bicycle.
Do not use bicycle covers, bicycle bras, or bikes equipped with rear disc wheel.
Not intended for off road use. Not intended for use on trailers or towed vehicles.
Locks are only deterrents to thieves, RockyMounts, Inc. cannot be held liable for stolen bicycles.
Check all fastenings (nuts, bolts, straps, and skewer) before each use.
Once a year, remove HotRod from car. Clean and inspect for damage.
Shop for other bike racks on our website.
