To order parts and supplies: 800.343.9353 >> eastwood.com
5
SET-UP & CONNECTION
• Wrap white thread sealing tape (not included) around the threads of the 1/4” Male NPT quick
disconnect fitting, then thread it into the 1/4” NPT inlet threads of the Cut-off tool.
• Attach Air Supply to Inlet Fitting.
SET-UP
• The Cut-Off Wheels are removed
and installed by gripping the
flats on the output shaft with the
included Flat Wrench while placing
the Included Hex Key Wrench into
the Socket Head Wheel Retaining
Screw threaded into the shaft. Turn
the screw in a counter-clockwise
direction when viewed from the
end. Remove Retaining Washer
(note outward orientation of beveled
edge) then remove cutting wheel
(FIG 1)
.
• Place replacement wheel over the stepped 3/8” [9.5mm] diameter portion of the shaft, replace
Retaining Washer in the proper bevel-out position then use the wrenches to tighten
(FIG 1)
.
Be sure that the air supply to the tool is clean and dry.
Moisture in the supply line will quickly damage the air motor and valves.
A minimum 3/8” I.D. air line should be used for optimal performance.
INJURY HAZARD!
Disconnect air supply from the tool to prevent accidental starting and
potential injury while installing or removing Cut-off Wheels.
Be sure the Socket Head Wheel Retaining Screw is securely tightened on the
output shaft before operating tool.
FIG. 1
Содержание 31741
Страница 1: ...3 CUT OFF TOOL INSTRUCTIONS Item 31741...
