Rockwell RS2112, Руководство пользователя, Страница: 9 / 12

9
CORDLESS DRILL EN
TEChNICAL DATA
OPERATINg INSTRuCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. ChARgINg ThE BATTERy (See Fig. A)
ChARgINg PROCEDuRE
1) Plug the charger into an appropriate outlet. The
light (a) will be green.
2) Insert the Battery Pack (6) into the charger, the
light (b) will be red and flash to indicate the
charging process has started.
3) On completion of charge, the light (a) is green, and
light (b) will illuminate red, and won’t flash. The
pack is now fully charged, unplug the charger and
remove the battery pack.
wARNINg: When battery charge runs out after
continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before
re-charging to achieve the full charge.
ChARgINg INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned to
a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Light ON/OFF Flash Status
Green on
Red flash
Charging
Red flash
Green flash
Defective
Battery
Green on
Red on
Fully Charged
Green Off
Red flash
Hot/Cold Delay
2. TO REMOvE OR INSTALL BATTERy PACK (See Fig. A2)
Depress the Battery Pack Release Button (5) to
release and slide the battery pack out from your tool.
After recharge, slide it back into your tool. A simple
push and slight pressure will be sufficient.
OPERATION
1. ON / OFF SwITCh (See Fig. B)
Depress the On/Off switch to start and release it to
stop your drill. The on/off switch is fitted with a brake
function which stops your chuck immediately when
you quickly release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
wARNINg: Do not operate for long periods
at low speed because excess heat will be
produced internally.
2. SwITCh LOCK
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the rotation control in the center position.
3. REvERSIBLE (See Fig. C1,C2)
For drilling and screw driving use forward rotation
marked “ ” (lever is moved to the left). Only use
reverse rotation marked “ ” (lever is moved to
the right) to remove screws or release a jammed drill
bit.
wARNINg: Never change the direction of
rotation when the chuck is rotating, wait until it
has stopped!
4. ChuCK ADjuSTMENT (See Fig. D)
To open the chuck jaws rotate the front section of
the chuck. Insert the drill bit between the chuck jaws
Charger voltage
Battery voltage
No load speed
Number of clutch positions
Max torque
Chuck capacity
Max. drilling capacity
Steel
Wood
Charging time
Battery capacity
Machine weight
100-240V~ 50Hz 20W
12V
0-700 /min
18+1
12N.m
0.8-10mm
6mm
19mm
1hr
1.3Ah Li-Ion
0.96kg