LITHIUM ION CORDLESS IMPACT DRIVER
ENG
7
SYMBOLS
WaRNiNG-To reduce the risk of injury,
user must read instruction manual.
Warning
Wear ear protection
Wear eye protection
Wear dust mask
indoor use only
do not expose to rain or water
do not burn
direct current
n
o
No-load speed
TECHNICAL DATA
Voltage
18 V
No load speed
0-2400 rpm
impact rate
0-3000 bpm
Max torque
1160 in-lbs
Chuck size
1/4˝ hex
Machine weight
3.1 lbs
Charging time
30 min
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction
book carefully.
CHARGING
1. CHARGING THE BATTERY
The battery charger supplied is matched to the Li-ion
battery installed in the machine. do not use another
battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The chuck no longer
rotates.
in a warm environment or after heavy use, the battery
pack may become too hot to permit charging. allow time
for the battery to cool down before recharging.
When the battery is charged for the first time and
after prolonged storage, the battery will only accept
approximately 60% charge. however, after several
charge and discharge cycles the battery will accept a
100% charge.
2. INSTALL THE CHARGER STANDS (See Fig.A)
slide the two charger stands (a) into the both grooves
on back of the charger. The charger can stand as shown
in Fig.a.
3. HOW TO CHARGE YOUR BATTERY (See Fig.B)
Connect the battery charger to the power supply and the
green light (b) will illuminate.slide the battery pack (6)
into the charger to make the connections. The green light
(b) will be off and the red light (c) will illuminate to show
charging has started. When charging is completed the
green light (b) will illuminate while the red light (c) is off.
NOTE:
This charger is designed to detect some problems that
can arise with battery pack. (see table below)