7
12V Cordless osCillating tool
eng
teChniCal data
oPeration instrUCtions
note:
Before using the tool, read the instruction book
carefully.
1. moUnting aCCessories
CaUtion: For all work or when changing accessories,
always wear protective gloves and make sure battery is
removed. avoid danger of injury from the sharp edges of the
accessories. accessories can become very hot while working,
presenting danger of burns!
Warning: to reduce the risk of injury, do not let the
sharp side of the accessory face back toward the user’s
hand.
- loosen the Flange
Use the Allen Key to rotate the Flange clockwise.
(See Fig. A)
- insert accessories
Insert the Accessory onto the Universal Fit
TM
Accessory Interface.
(See Fig. B)
- tighten the Flange
Use the Allen Key to rotate the Flange counterclockwise until
accessory is tightened securely.(See Fig. C)
note:
For prior model Rockwell Sonicrafter
®
hex-interface
accessories and most other non-Rockwell branded accessories, the
Flange must be completely removed to install accessory.(See Fig. D)
2. moUnting / Changing the sanding sheet (see Fig. e)
Align the sanding sheet and press it onto the sanding pad by hand.
Firmly press the power tool with the sanding sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the sanding sheet, turn it 120°
and place it on again.
note: For other various brands, use smaller flange provided.
Voltage
Oscillations speed
Oscillations angle
Tool weight
12 V
5000-20000/min
3.2°
2.25 lbs
A
B
C
E
F1
F2
F3
F4
F5
G
D
Содержание RK2522K2
Страница 30: ......
Страница 31: ......
Страница 32: ...Copyright 2012 Positec All Rights Reserved 2CDS80BPK11000A0...