Rockwell Automation Allen-Bradley VersaView 6300M Series, Руководство пользователя

Страница: 19 / 36

Rockwell Automation Publication 6300M-UM001A-EN-P - December 2021 19
Chapter 2 Install the Monitor
6. Slide the mounting clips into the holes on
all four sides of the monitor as shown at
right. For the various hole locations, see
Figure 5 .
7. Hand-tighten the mounting clips
according to the tighten sequence in
Figure 5 .
8. With the torque limiting screwdriver and 1.5 mm hex key bit, tighten the
mounting clips to a torque of 0.2 N•m (1.8 lb•in) by the tighten sequence
in
Figure 5 .
9. Repeat this process at least three times until the clips are properly
torqued to 0.2 N•m (1.8 lb•in).
Verify that the gasket is compressed uniformly against the panel.
Figure 5 - Tighten and Torque Sequence for the Mounting Clips
Connect Peripheral Cables
to the Monitor
Connect peripheral cables to the appropriate I/O ports on a VersaView 6300M
monitor. To comply with EN 61326-1, use the following for cable types. All I/O
cables must be used only indoors, and USB cables must be less than 3 m
(9.84 ft) long.
ATTENTION: Tighten the mounting clips to the specified torque to provide
a proper seal and to help prevent product damage. Rockwell Automation
assumes no responsibility for water or chemical damage to the monitor or
other equipment within the enclosure because of improper installation.
I/O Ports
1 8
7 2
4
5
6
3
All Bezels Except
Stainless Steel
8.4…15 and 17 in. Display Sizes
I/O Ports
10 1
6 2
3
8
7
4
9
5
All Bezels Except
Stainless Steel
15.6 and 19 in. Display Sizes
I/O Ports
All Bezels Except Stainless Steel
21.5 and 24 in. Display Sizes
10 1
6 2
3
8 14
4
9
5
7
12
13
11
I/O Ports
All Bezels Except Stainless Steel
18.5 in. Display Size
10 1
6 2
8 4
9
5
7
12
3
11
1 8
7 2
4
5
6
3
Stainless Steel Bezel
(IP66 rating)
12.1 in. Display Size
I/O Ports
I/O Ports
Stainless Steel Bezel
(IP69K rating)
10.1 in. Display Size
10 1
6 2
3
8
14
4
9
5
7
12
13
11
I/O Ports
10 1
6 2
3
8
7
4
9
5
Stainless Steel Bezel
(IP66 rating)
15, 17, and 19 in. Display Sizes
1
2
3
7
4
8
Table 2 - Peripheral Connections for Standard Monitors
Item
No.
Cable
Type
Required
Attribute
Item
No.
Cable
Type
Required
Attribute
1 DisplayPort
Shielded
5 USB 2.0
(1)
(1) Optional feature.
Shielded
2 DVI-D 6 USB 2.0
(2)
(2) Only certain models offer a USB 2.0 port on the front bezel.
IMPORTANT: USB ports on front bezels of 6300M-xxxBA and 6300M-xxxBB monitors are not
for use in hazardous locations.
3 USB HUB 7 DC power
Unshielded
4 3 x USB 2.0 8 AC power
5
6