Rockwell Automation Publication 2711T-QS002C-EN-P - March 2019
9
Second Generation MobileView Tethered Operator Terminal
To install the cable, perform the following steps.
1.
Decide on which cable-connection port of the terminal to install the cable; see
Figure 2 - Cable Connections on MobileView 2711T Terminal
2.
If you want left-hand operation, remove the plug with an 8 mm hex key.
Set the plug aside.
3.
Remove the back cover as detailed on
4.
If present, unscrew and remove the gray fitting from the connector-cable mounting
assembly.
5.
Unscrew the strain relief from the connector-cable mounting assembly to allow the red
cable to slide freely.
Back Cover
Cable connection
with open port
(as factory shipped).
Cable connection
with hex plug
installed.
IMPORTANT
The second generation MobileView 2711T terminal is shipped with the above cable-connection
port open for right-hand operation.
When the 22-pin cable is connected to this port, you can hold the terminal with your left arm,
operate the enabling switch with your left hand, and operate the terminal touch screen with your
right hand.
Strain Relief
Connector-cable
Mounting Assembly
Gray Fitting
