Rockwell Automation Allen-Bradley 6181X-12A2SW71DC, Allen-Bradley 6181X-00N2SW71DC, Allen-Bradley 6181X-12A2SWX1DC, Allen-Bradley 6181X-00N2SWX1DC,, Руководство пользователя

Страница: 35 / 78

Rockwell Automation Publication 6181X-UM002A-EN-P - October 2017 35
Replace Components Chapter 4
Replace a Solid-state Drive
See Hardware Features on page 11 for the SSD location.
Follow these steps to replace a SSD tray in the SSD bay on the side of the
computer.
1. Follow the steps for Pre-configuration on page 32 .
2. Loosen the screw that secures the slot cover of the drive bay (A).
3. Loosen the screw that secures the drive bay lever (B).
4. Open the drive bay lever (C).
5. Pull out the existing SSD tray (D).
6. Push in the new SSD tray (E).
7. Close the drive bay lever (F).
8. Tighten the screw that secures the drive bay lever (G).
9. Tighten the screw that secures the slot cover of the drive bay (H).
10. Follow the steps for Post-configuration on page 33 .
WARNING: The solid-state drive (SSD) bay on the side of all computer
models is not hot-swappable. You must first shut down the computer before
you can insert or remove a SSD tray from this bay.
Do not connect or disconnect components unless power has been switched off
and the area is known to be non-hazardous.
WARNING: Use only catalog numbers 6189X-128GBSSD and
6189X-256GBSSD drive trays in the 6181X computers for hazardous locations.
Substitution of components can impair suitability for hazardous locations.
IMPORTANT For computers in ATEX and IECEx applications, both screws for the
drive bay (steps G and H in the illustration below) must be hand-
tightened and verified as secure.
C
B
A
D
F
G
H
E
Display Computer Shown