Rockwell Automation Allen-Bradley 2198-K5700-MOUNTKIT, Руководство по установке

Страница: 7 / 12

Rockwell Automation Publication 2198-IN012B-EN-P - February 2019 7
Kinetix 5700 System Mounting Toolkit
Figure 4 - Drill Hole Guide Map After Using 220 mm Wide Modules
Use the Drill Hole Guide with 275 mm Wide Modules
Follow these steps to locate the drill-holes for your 275 mm wide modules in your Kinetix 5700 drive system:
1. Complete steps 1...3 from Install the Mounting Bar and Position the Drill-hole Guide . See Figure 2 to see location and labels of holes and
slots on the drill-hole guide. Figure 5 shows the finished drill-hole map and the steps where each mark was made. The figure is not to scale.
2. Draw a vertical line where the left side of the module is to be installed.
3. Slide the drill-hole guide into the mounting bar and adjust left-to-right until the 100 mm upper module-width hole is aligned with the
vertical line you drew in step 2.
4. Mark the top left 100 hole and bottom left 100 hole locations.
5. Shift the template left to align the vertical line you drew in step 2 with the leftmost 55 slot.
6. Draw a line in the rightmost 55 slot.
7. Shift the template to align the line you drew in step 6 to the leftmost 55 slot.
8. Draw a line in the rightmost 55 slot.
9. Shift the template right to align the line you drew in step 8 with the leftmost 100 slot.
10. Mark the top left 100 hole and the bottom left 100 hole locations.
11. Shift the template left to align the rightmost line to the leftmost 55 slot.
12. Draw a line in the rightmost 55 slot.
13. Shift the template to align the line you drew in step 12 to the leftmost 55 slot.
465 mm
Step 4
Step 14
Step 2
Step 6
Step 8 Step 10 Step 12