LIGHT MODES
BLUETOOTH
CHARGING
Please make sure the unit is fully charged before using for the first time.
Charge the speaker using the provided USB cable by connecting it to any
computer or 5v cell phone charger. The charging LED indicator will remain red
while charging and will turn off once the unit is fully charged. Charging time is
approximately 4 hours. On a full charge, the unit has a playback time of
8 —10 hours at 70% volume.
The PBL20 has variety of light modes. Touching the speaker mesh for 5 sec-
onds will switch the unit between lamp mode and color mode.
LAMP MODE:
To activate lamp mode simply push the speaker mesh. This
will set the lamp to its lowest mode. There are three levels to choose from:
low, medium, and bright. To increase lamp brightness, touch the speaker
mesh until desired brightness is achieved. Once the lamp is at its brightest
setting, touching the speaker mesh again will turn it off.
COLOR MODE:
You can change the speaker to multi-color mode (AKA cool
mode) by touching the speaker mesh for 3 seconds. Once in this mode, touch
the speaker mesh to change colors. Continue touching to reach color cycling
mode and rhythm mode.
When the PBL20 is turned on it automatically enters Bluetooth mode. If the
unit has been previously paired, it will automatically connect to that device. If
no device has been paired, upon being powered on, the unit will enter paring
mode. The blue indicator LED will flash and you will hear voice prompts.
You may only connect one device at a time. To connect a different device,
be sure to turn off Bluetooth mode on the curently connected device and