Rockville HTS56, Руководство пользователя

Страница: 13 / 16

13
MIC INPUT
To use the system for karaoke connect any microphone via either one of the ¼ ˝ inputs
located on the front of the unit. While the MICs are connected, you can control the mic
volume by pressing the MIC- or MIC+ buttons on the remote. Additionally, you can con-
trol the mic echo effect settings by pressing the ECHO- or ECHO+ buttons on the remote.
TROUBLESHOOTING
PROBLEM
No sound
No sound from mics
No power
Make sure the unit is plugged in and the power switch is
in the ON position.
Bluetooth pairing fails
No SD or USB memory
device playback
1. Make sure the mics are turned on and properly connected.
2. Adjust the mic volume on the remote control.
3. Check individual speaker volume controls as well as
the master volume.
1. Check to see that both devices are turned on and that
your Bluetooth device is discoverable.
2. Turn both devices off and then on again.
3. Make sure you've selected the proper source.
4. Make sure that the Bluetooth device is within 5 feet of
the unit.
5. Move both devices away from other Bluetooth devic-
es, microwaves, wireless routers, and other electronics.
6. Make sure that the unit is not paired to a previously
paired device.
SOLUTION
Poor or no radio reception 1. Make sure antenna cables are properly connected and
above the unit.
1. Make sure you've selected the proper source, USB/SD
(see page 11).
2. Make sure that the audio files are in the proper format
(see page 14).
3. Make sure you are not exceeding the SD card and
USB drive size limitations (see page 14).
4. Make sure that the SD card or USB drive is properly
plugged in.
5. Check the SD card or USB drive for damage.
1. Make sure you've selected the proper source.
2. Make sure all speakers are properly connected.
3. Check individual speaker volume controls as well as
the master volume.
4. Check the input source’s volume settings.
5. Make sure you’ve selected external speakers in your
TV’s sound ouput settings.
6. Deactivate Dolby Pro-Logic, Dolby ATMOS, etc. and-
select PCM in your TV’s sound format settings.
7. Check all connections between the receiver and the
input source.
Go to the URL or scan the qr code on the left for helpful
information.
vimeo.com/473203709