ONESUB & DUBSUB | OWNER’S MANUAL
Please read the following instructions carefully before installing your Rockustics
®
Rock speaker. If you have any questions
regarding installation that are not answered in the following directions, please contact your local sound contractor or the
Rockustics
®
/MSE Audio
®
technical support team. Contact information can be found on the back of the manual.
OneSub™
The terminal block is on the underside of the OneSub. 14 gauge or heavier direct burial wire should be run directly from an
amplifier with an integrated low frequency crossover (we recommend a Phase Technology P350 amplifier. Please see P350
manual to setup crossover point) to the speaker location. Stripped wire ends are then inserted into the terminal blocks.
DubSub™
The dual terminal blocks are on the underside of the DubSub. 14 guage or heavier direct burial wire should be run directly from
a dual channel full range amplifier. The DubSub has an integrated crossover that will route the low frequencies to the DubSub,
and the rest of the signal to the satellite speakers.
Wires from the amplifier are wired to the ‘in’ terminals, and satellite speakers are wired to the ‘out’ terminals.
INPUT
12V TRIGGER
UNBALANCED
BALANCED
OUTPUT
TRIGGER
MODE
IN
OUT
MUSIC
ON
12V
4-16 OHMS
INPUT
VOLTAGE
POWER
ON
OFF
115V 60 Hz/ 230V 50 Hz
AC INPUT 600W MAX
PUSH
115V
+
+
-
-
P350
OS-440
L
R
L IN
L OUT
R OUT
R IN
In
Out
In
Out
+
+
-
-
+
+
-
-
Terminal Block
Terminal Block
