Escape Series
INSTALL INSTRUCTIONS
© 2021 MSE Audio. Rev. 02.19.2021
Ultra-Fidelity Outdoor Speakers
Contact: MSE Audio, 855.663.5600 / 913.663.5600 / [email protected]
+
__
__
-
-
1.
2.
+
4. Daisy-Chaining
If daisy-chaining, be sure to also
connect the wires going to the
next speaker in the chain. Follow
standard protocol for polarity and
make sure the subwoofer is wired
with the same polarity as the
Periscape units.
1. Install Cap
Install the cap by threading it onto
the end of the port tube clockwise.
Daisy Chaining Wiring
Wire Nuts
Speaker or
Subwoofer
Daisy-Chained
Speaker or
Subwoofer
Signal Wire
3. 70V Applications
For 70V (or 100V) applications,
select the appropriate tap wires
from the chart on page 3 and
connect them to the input wire
from the amp. Skip to step 5 if
using 8 ohm.
3” to 5”
8. Complete Install
Place subwoofer in hole and fill.
Leave 3-5” of space from the
bottom of the cap to the ground.
Gray
Green
White
8 Ohm -
Red
8 Ohm +
8 Ohm Wiring
Heat Shrink Cap
5. 8 Ohm Application
Locate the red, gray, green, and
white wire pairs and cut off the
heat shrink cap on each pair. Use
the supplied wire nuts and connect
the positive (+) lead from the amp
to the red wire and connect the
negative (-) lead from the amp to
the white wire. Do not use the gray
or green wire. Disregard if using
70V Wiring.
7. Trim Wires
Trim unused wires on the sub-
woofer and wrap the loose ends
with electrician’s tape or a suitable
alternative to protect the bare
wires from corroding.
6. Test
Fully wire the rest of your system
and test to make sure sound is
coming from each unit.
2. Digging
Dig a hole sufficient to bury the
Subscape so that there is 3-5”
clearance between the bottom of
the port and the ground level. Be
sure to account for several inches
of gravel at the bottom to assist
with drainage.
SUBSCAPE INSTRUCTIONS
