Back Panel
1
2
3
4
CHAN/EFX FOOTSWITCH (Footswitch) Jack
To control CHANNEL selection, plug a single footswitch* into this jack. To control CHANNEL
Selection and DIGITAL EFFECTS ON/OFF, use a double footswitch* with a stereo 1/4” jack.
PREAMP OUT - TO EXT POWER AMP
This 1/4” jacks allows you to connect to a seperate powered speaker cabinet or directly into a power
amp - like the Rocktron Velocity 100 and from the power amp into two 4x12s, a stereo 4x12 or a
stereo 2x12 cabinet. The preamp output is controlled by the master volume control.
LINE OUT - TO RECORDING DEVICE
This 1/4” jack allows you to connect to a PA system or recording device. The Speaker Simulator is
always engaged for the best sound. You may also run the signal out to a power amp with volume
controls and from there into a speaker cabinet. This output is ideal for direct connection to a PA
system for live performances....it eliminates the need to use a microphone with the PA. The line
output is not controlled by the master volume control.
POWER INLET Module
The Power Inlet module accepts the detachable power cord included with the unit.
CD INPUTS
These two RCA jack inputs allow for a direct connection by a CD player or Tape player to the ampli-
fier. You can then jam along with CDs or tapes to rehearse songs, learn new songs or just for fun!
Warning!!! When using Headphones with the CD inputs - make sure you turn down the
Levels on both channels BEFORE unplugging headphones - otherwise excessive CD volume
will be produced.
6
5
* Rocktron Rampage single (RFS1) and double (RFS2) footswitches are available and sold
separately.
SPEAKER OUTPUT Jacks - Right & Left
Used to connect additional speaker cabinets if desired. The R50DSP will drive a 4x12 and sounds
awesome. Connect only one additional 8 ohm cabinet per jack. Do not connect more than one per
jack or you will damage your amp!
