12
Fig. 21
After finishing mounting the counterweights, put down the guard and press
，
to perform balancing spin again, if
comes out 00 00
，
means balancing succeed. (Fig.22)
Fig. 22
4.4. ALUS split function
Note: Only ALU-S mode can use this function. And Operator must be experienced.
1
In ALU-S mode, press
comes
＞
2
By key
and
to input the numbers of
spokes, then press
comes
＞
3
Keep the next spoke( either direction is ok) on
the position of 12 o’clock, press
comes
＞
4
Anticlockwise rotate wheel by hand slowly,
until the outside SP1 LED lit up full, add the
adhesive weight
（
to stick the weights on
position of 9 o’clock or else depends
LAS=On or Off
）
）
comes
＞
5
Anticlockwise rotate wheel by hand slowly,
until the outside SP2 LED lit up full, add the
adhesive weight
（
to stick the weights on
position of 9 o’clock or else depends
LAS=On or Off
）
）
comes
＞
