Rockler Pro Lift, Инструкция по эксплуатации

Страница: 9 / 12

9
8. Tighten the housing by removing the spreader bolt from
the middle hole and tightening the two outside bolts
securely. (Keep the spreader bolt and store it in a place
where it will be readily available for future use, or reinstall
it without fully tightening.) Fig. 10.
9. Check the column-locking knob to make sure it is not
tightened. Do not tighten unless you intend to lock in a
particular bit height setting. Fig. 11.
10. Fit the assembled Pro Lift and router motor into your
router table’s opening. Use the leveling screws that came
with with your router table to bring the plate flush to the
table on all edges. Fig. 12. Then secure the lift to the table
by using the M4 hex wrench to install the two included
1/4"-20 plate-mounting screws.
Fig. 11 Fig. 12
Fig. 10
To avoid serious injury, never attempt to
cut a workpiece without an Insert Ring installed.
11. Before use, snap the Insert Ring back into the plate’s
center opening.
Installing/Changing Router Bits
1. Press the Snap-Lock Insert Release Button to pop the
aluminum Snap-Lock Insert Ring off the plate.
Tighten these bolts
Leveling screws on
your router table
Threaded insert
to accept 1/4”-20
plate mounting
screws