8
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
Distributed by Rockler Companies, Inc.
Medina, Mn 55340
59032
Rev 05/22
Fig. 8
Fig. 9
Fig. 10
3.
For successive cuts, reposition Workpiece A with
the previous cut over the Indexing Key and hold or
clamp in place. Slide the Sled forward across the bit
and then back to the starting point to make the cut.
Repeat until all cuts have been made on that edge.
Fig. 8.
4.
To make the first cut in the adjacent side
piece (Workpiece B), use the original
piece (Workpiece A) as a spacer. Position
Workpiece A with the top edge positioned as
shown in
Fig. 9
. Butt Workpiece B against
Workpiece A, hold or clamp the workpieces
and make the cut.
5.
Remove Workpiece A, reposition Workpiece B so
the area just cut is on the Indexing Key, hold or clamp
it in place and make the second cut.
Fig. 10.
For
successive cuts, reposition Workpiece B with the
previous cut over the indexing key. Repeat until all
cuts have been made on that edge.
6.
To make the cuts in workpieces C and D, follow
the process outlined in Steps 2-5.
B
T
A
T
T
A
B
B
T
B
