4
Distributed by Rockler Companies, Inc.
Medina, Mn 55340
53651
Rev 03/18
Fig. 5
Fig. 6
Fig. 7
7. Remove the Square Template and check that your board
looks like the one shown in
Fig. 5.
8. Install the Rounded Template so that its two rearmost
outside holes are over the most recently drilled indexing
holes. Press the Indexing Pins in these holes to hold the
template; then drill the holes outlined in red in
Fig. 6.
9. Move the Indexing Pins to the holes shown in Fig. 7
and drill the holes outlined in red.
10. Remove the Round Template and sand the board surface.
Check Rockler.com for updates. If you have further questions, please
contact our Technical Support Department at 1-800-260-9663
If you want a curve on the end of your
board, you can use the Round Template as a pattern and
trace the outline.
Holes drill in Steps 4-6
Indexing Pin
Indexing Pin
Indexing Pin
Indexing Pin
