16
LIGHTING INSTUCTIONS
WARNING: IMPORTANT!
BEFORE LIGHTING...
Inspect the gas supply hose prior to turning
the gas “ON”. If it is evident there is excessive
abrasion or wear, or the hose is cut, it must be
replaced prior to the grill being put into opera-
tion. The replacement pressure regulator and
hose assembly shall be that specified by the
manufacture. Do not use the grill if the odor of
gas is present. Only the pressure regulator and
hose assembly supplied with the unit should
be used. Never substitute regulators for those
supplied with the grill. If a replacement is nec-
essary, contact the factory for proper replace-
ment.
Screw the regulator (type QCC1) onto the cyl-
inder. Leak check the hose and regulator con-
nections with a soap and water solution before
operating the grill, see leak testing section.
Burner flame should be blue and stable with
no yellow tips, excessive noise, or lifting. If any
of these conditions exist, call our customer
service line. If the flame is yellow, it indicates
insufficient air, potentially creating carbon
monoxide. If the flame is noisy and tends to lift
away from the burner, it indicates too much air.
TO LIGHT THE GRILL BURNER
Always keep your face and body is far from the
grill as possible when lighting.
1. Read instructions before lighting.
2. Make sure battery is replaced periodically
in “Ignitor” in order to ensure proper opera-
tion.
3. Make sure burner knobs are in the “OFF”
position
4.
Turn on propane valve counterclockwise
until stops located in bottom of grill and
shut bottom doors.
5. Open top door, step to your LEFT.
6. Push and turn control knob #1 counter-
clockwise to “MAX” position.
7. Push “ignitor” button until burner #1 lights.
8. With burner #1 lit, push and turn control
knob # 2 counter clockwise to “MAX” and
ensure burner #2 is lit.
9. Repeat this process for burners #3 and 4.
10. If Ignition does not occur in 5 seconds, turn
the burner control off, wait 5 minutes, and
repeat the lighting procedure.
11.
To turn off turn control knobs clockwise until
it locks in “OFF” position.
12.
Open bottom doors turn off the cylinder
valve by turning knob clockwise until it
stops.
HOW TO REPLACE BURNERS
1.
Remove S.S. grates - simply pickup and set
outside.
2.
Remove S.S. cover over crossover tubes
3.
Remove S.S. screws from crossover tubes
with Philips screwdriver.
4.
Remove S.S screw from back of burner
with Allen wrench.
5.
Remove S.S screw from Igniter from burner
with phillips screwdriver.
6. Replace burner and reinstall according to
the above steps 5 to 1 in that order.
Keep a spray bottle of soapy water near
the gas supply valve and check the con
-
nections before each use
Do not attempt to light the grill if odor of
gas is present. Call for customer service.
1.605.868.6840
