14
S
PECIFICATIONS
MODEL- POWER
T2500-1bd
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Mono
1000 Watts x 1
2 Load Mono
1800 Watts x 1
1 Load Mono
2500 Watts x 1
Continuous Power Rating (RMS) - Two Amplifiers in bdSYNC Configuration
2 Load Bridged/Mono
5000 Watts x 1
Dimensions:
Height
2.14" (5.44cm)
Width
8.14" (20.68cm)
Length
21.875" (55.66cm)
Battery Fuse Rating (Amp) External (Not Supplied)
300A
“A” Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
≥70 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
≥100 dB
Crossover Slope
24dB/octave Butterworth
Crossover Frequency (Low Pass Only)
variable from 35Hz to 250Hz
Frequency Response
20Hz to 250Hz ±0.5dB
Signal Voltage Adjustment Range
Variable from 150mV to 5V (RCA Input)
Protection
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in
case of overheating.
Equalization PEQ (Punch Equalization)
Variable from 0dB to +18dB @ 45Hz
Input Impedance
20K ohms
Infrasonic Filter
Selectable 12dB/Octave, -3dB @ 28Hz
Operating Voltage
9 to 15.5 Volts DC
Balanced Inputs
Yes
CMRR (Common Mode Rejection Ratio)
>55dB @ 1KHz
Damping Factor
>200
THD+N (Total Harmonic Dist Noise)
< 1% @ 1 ohm
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
