P9
SIRIUS OPERATION
7. Display channel information:
Press DISP button repeatedly to display different information of the channel such
as channel #, channel name, category, song title, artist, composer...
8. Message display:
"Check Sirius Tuner":
Tuner
is
not
connected
or
is
bad
.
"Antenna
Error"
Antenna
is
bad
or
not
connected
.
"Acquiring
signal"
No signal output from the Sirius TUNER
"Updating " Updates the Sirius information into unit.
"FW Updating"
Updates
firmware
"Subscription
updating"
Updates
subscription
"Updating
Channels"
Updates
the
GCI
(
Channel
info
)
6. Parental Control
You can lock any Sirius channels you do not others to have access without your
permission. The default code is "5220"if you forget your pass code, you may
disconnect the unit completely from power. The unit will restore to the default
pass code after power on again. Enter a Locked channel: When user tunes to
a locked channel, the LCD screen will display: "LOCKED CH" first and then display:
"CODE X X X X".
Press Preset 1 repeatedly to select the first digit of pass code.
Press Preset 2 repeatedly to select the second digit of pass code.
Press Preset 3 repeatedly to select the third digit of pass code.
Press Preset 4 repeatedly to select the last digit of pass code.
When all digits are selected, press "SEL" button will enter the channel.
If the code is wrong, it will display "CODE X X X X" again and wait for user to enter
code again. If user enters a wrong code again, the unit will display "PWD ERROR"
and go back to previous screen.
Note: user needs wait for "CODE X X X X" display to enter pass code. Otherwise
the Preset 1-4 still enters as Preset station.
To lock a channel:
When a channel is selected, use "SCAN" to lock this channel. The LCD will display
"LOCK CH" first and then display: "CODE X X X X".Use Preset 1-4 (same as above)
to enter pass code and press SEL to lock.
Note: After a channel is locked, user cannot tune to this channel by SEEK+/- button.
User must input the channel # directly to enter this channel.
To unlock a channel:
User needs enter the locked channel first and then short press "SCAN"button.
The LCD will display "UNLOCK CH" and then display: "CODE X X X X".
Same procedure as above to enter the code and unlock the channel.
To change pass code:
Long press "SCAN"button to change the pass code. The screen will display
"OLD CODE"shortly and then display "CODE X X X X" Use Preset 1~4 buttons
as above to enter the pass code.
If the old pass code is entered correctly, the screen will display "NEW CODE" and
then display: "SET X X X X" Use Preset 1-4 buttons again to set up a new pass code.
P8
SIRIUS OPERATION
